Announcement

Collapse
No announcement yet.

Wood Magazine's Wood Working Show - Chantilly, VA, March 23-25

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Wood Magazine's Wood Working Show - Chantilly, VA, March 23-25

    Is anyone going to this one? I missed the Baltimore show, so I'm going to try.

    http://www.thewoodworkingshows.com/chantilly.html
    Tony

    My Son-in-law said "Darnit, I cut this board twice, now. And it's still too short."

  • #2
    Doubtful but I am still considering it. Guessing close to 4 hours each way to go less then 200 miles and over 1/2 the trip is at 70 mph. I hate the traffic in Northern Virginia. Some of the worst in the country.
    Scott
    Creator of fine designer sawdust.

    Comment


    • #3
      That’s why Bruce refuses to drive on 495. Crazy people!!!! So we aren’t going.
      Betty

      "Congress needs to realize it is a government of the people, by the people and for the people. Not of the people, by the people and for Congress." - Dr. Benjamin Carson, Pediatric Neurosurgeon, Johns Hopkins Hospital

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • Dan A
        Reply to Last weekends wood show
        Dan A
        Congratulations, Rolf

        Dan
        Today, 06:15 PM
      • Rubsterwine
        Reply to My hegner is chopping thru wood
        Rubsterwine
        Thanks guys: The blade is not being pinched. I have parts list and diagram, the bearing on the crank linkage are sealed but I have on order a new linkage with bearings. Yes I oil the bushings every couple of weeks. I thought maybe the screws on the upper clamp might worn to much so I removed the two...
        Today, 03:48 PM
      • Sandy Oaks
        Reply to Christmas show stuff
        Sandy Oaks
        Wow, Tony. Those are amazing. Thanks for showing the glue up.
        Today, 11:20 AM
      • will8989
        Reply to My hegner is chopping thru wood
        will8989
        Check the thumb screw in the upper holder. On the end is a tiny screw that must be perfectly flat. If it’s not it won’t grab the blade properly. I replace mine every few years. The problem this time is with #5 blades. The bottom of the blade is not even and I believe that is my problem. The other...
        Today, 11:11 AM
      • handibunny
        Reply to Christmas show stuff
        handibunny
        Thanks, Tony. That's what I thought you'd have to do. Your work is impeccable!
        Today, 11:00 AM
      Working...
      X