Announcement

Collapse
No announcement yet.

Columbus Woodworking Show

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Columbus Woodworking Show

    I will Be at the Columbus Woodworking Show this weekend, Along with "The Heart Of Ohio Scrollers" We will be doing demos and cutting ornaments for project Rudolph. Would love to meet any forum members. Please stop by.
    Thanks
    Bruce Shea
    Last edited by daytonsawman; 01-18-2018, 09:30 AM.

  • #2
    Too far for me. Hope you have a great event.
    Scott
    Creator of fine designer sawdust.

    Comment


    • #3
      Is thiis a yearly event ? I am moving back to Springfield Oh in Dec. 2018 If it going to happen again in 2019 I would like more information thanks

      Comment


      • #4
        Check online for the woodworking show schedule it will give dates and places for 2019.
        Betty

        "Congress needs to realize it is a government of the people, by the people and for the people. Not of the people, by the people and for Congress." - Dr. Benjamin Carson, Pediatric Neurosurgeon, Johns Hopkins Hospital

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • will8989
          Advent wreath
          by will8989
          For one of my good customers. From the fall issue 2016. Cherry and African mahogany. Bruce turned the candle holders as we couldn’t find candles to fit any already made wooden holders. I used the green sparkle unicorn spit over green paint for holly leaves and red for the berries. Yes, I actually...
          Yesterday, 11:39 PM
        • Ennobee
          Reply to 10" long truck.
          by Ennobee
          Looks pretty neat. So it's from a 2x4: 3 in wide, 'bit less then 2 in. high? So how did you get the trunk cut out? You mentioned cutting the sides with a scroll saw, did you slice off two sides and then cut out the middle?...
          Yesterday, 09:46 PM
        • vgraf
          Reply to sanding sealer or shellac
          by vgraf
          I use sanding sealer on baltic birch plywood, pine and birch if I am going to stain them. Without the sanding sealer, the stain will be blotchy. I use the water base sealer from minwax. After it drys I sand to at least 150 grit and often to 220 grit. Wipe it with a tac cloth then apply the masking...
          Yesterday, 08:27 PM
        • Jim Finn
          Reply to 10" long truck.
          by Jim Finn
          We, our club, delivered over 900 toys last week to The Salvation Army, Ronald McDonald House, and a local children's hospital. Included were most of these trucks. (I sold a few)
          Yesterday, 07:17 PM
        • NC Scroller
          Reply to sanding sealer or shellac
          by NC Scroller
          The real nice thing about using shellac and alcohol mix for ornaments is you only have to wait minutes before you tie in your ribbons and packaging.
          Yesterday, 10:48 AM
        Working...
        X