Announcement

Collapse
No announcement yet.

Artistry in Wood show ?

Collapse
X
Collapse
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Artistry in Wood show ?

    I have a question for those of you that went to the show. Was Sandflee there or for that matter who if any of the vendors were there.?
    Rolf
    RBI G4 Hawk, Delta SS350, Nova 1624 DVR XP
    Philosophy "I don't know that I can't, therefore I can"
    Proud Member of the Long Island Woodworkers Club
    And the Long Island Scrollsaw Association
    Tags: None
  • #2
    I looked for Sandflee and Flatmaster. I wanted some sand paper. Neither were there.

    Ray from Seyco, Judy Gale Roberts, Steve Good were there. I have to confess there were a lot who offered wood carving equipment and supplies but I don't know who they were.
    Tracy

    Nicholasville, KY
    ​Excalibur 21"
    www.sawdustgallery.com

    Comment

    • #3
      Also Bob D was there with SSWC. Have to say it was nice to meet Ray & Steve Good. Very nice people.

      Comment

      • #4
        Never met Ray in person, talked to him a few times on the phone... A slow talking Texas gentleman...
        AKA Paul from Washington State

        Comment

        Previous template Next

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse
        • Don in Brooklin On
          Reply to wipe on poly and tack cloth
          by Don in Brooklin On
          I use wipe on poly quite often and I apply 2 thin coats before sanding with 220 or 320. I wipe with a lint free. Someone told me not to use tack cloth as you can leave behind a wee bit of beeswax witch could cause issues later on.

          I make sure that the surface is dry and not tacky before...
          Yesterday, 05:41 AM
        • dwssr2
          wipe on poly and tack cloth
          by dwssr2
          Question, when sanding polyurethane in between coats, using a tack cloth, is it ok to wipe on poly while the project seems tacky or should a person wait a few hours to let it dry?
          How necessary is it to sand between coats of polyurethane? I am sure people have a lot of different opinions and...
          04-24-2019, 05:58 PM
        • tgiro01
          Reply to Do you know what this Is?
          by tgiro01
          Betty asked: "Where does the responsibility of the maker of an item end and the responsibility of the purchaser begin? My sealife puzzle is purchased by older people due to its complexity but - if they leave it laying around and a child gets a part and chokes, is that my responsibility or theirs?"...
          04-24-2019, 12:20 PM
        • RJweb
          Reply to Do you know what this Is?
          by RJweb
          The problem now a days everyone is sue happy, no matter who’s at fault, RJ...
          04-24-2019, 10:03 AM
        • will8989
          Reply to Do you know what this Is?
          by will8989
          Don’t forget to carry insurance if you sell a lot. It’s a necessary expense and a good "silent" partner and hope it stays that way. Where does the responsibility of the maker of an item end and the responsibility of the purchaser begin? My sealife puzzle is purchased by older people due...
          04-24-2019, 08:44 AM
        View All
        Working...
        X