No announcement yet.

Thank you card

  • Filter
  • Time
  • Show
Clear All
new posts

  • Thank you card

    Shannon, Bob and the rest of the Fox Chappel crew.

    I want to thank you all for doing the open house and acknowledging the contributions of the forum members. I recieved a nice thank you card yesterday for my contribution to the charity auction.

    If you ever do another auction I would suggest doing it at something other than a scrolling / carving event. Most of the people at the event will look at the items and say "I can make that" and most of us can.

    Just a thought.
    RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
    Philosophy "I don't know that I can't, therefore I can"
    Proud Member of the Long Island Woodworkers Club
    And the Long Island Scrollsaw Association

Unconfigured Ad Widget


Latest Topics


  • handibunny
    Reply to Question about tilting head saws
    by handibunny
    If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. 😁

    Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
    Today, 05:09 PM
  • Jim Lowder
    Reply to Question about tilting head saws
    by Jim Lowder
    Thank you all for the info. Sounds like it’s talent or practice issue not my saws. Wife already gave permission to buy a new one. I will wait tho
    Today, 04:51 PM
  • hotshot
    Reply to Question about tilting head saws
    by hotshot
    I'll talk about this specific "slice" of your question, with more detail that you probably want or need.

    Most Tilting head saws do come from the same Taiwan factory, except Excalibur. So what happened with Excalibur was . . . General got bought by a Chinese investor, some China/Taiwan...
    Today, 04:41 PM
  • Linda In Phoenix
    Reply to Basket C15
    by Linda In Phoenix
    Did this thread get hacked? That is a very strange sidetrack from KyivWorkshop.
    Today, 04:21 PM
  • handibunny
    Reply to Question about tilting head saws
    by handibunny
    It doesn’t matter whether the saw table tilts or the saw arm tilts. Either can be used for any project cut at an angle, and there’s a learning curve for each.

    I actually prefer the tilting table because the blade remains vertical. I find that at really steep angles, like 40 or 45 degrees,...
    Today, 02:10 PM