Hi Gang,
Ramjet pointed out an error we had in the article. In step 5, we say to use a 1 1/2" Forstner bit to drill the key insert hole. Unfortunately, the fractional equivalent we put after the fraction was incorrect. You need to use a 38mm not a 13mm bit.
I'm sorry for the error.
Best Regards,
Bob Duncan
Technical Editor
Ramjet pointed out an error we had in the article. In step 5, we say to use a 1 1/2" Forstner bit to drill the key insert hole. Unfortunately, the fractional equivalent we put after the fraction was incorrect. You need to use a 38mm not a 13mm bit.
I'm sorry for the error.
Best Regards,
Bob Duncan
Technical Editor
Comment