Announcement

Collapse
No announcement yet.

Subscription Info

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Subscription Info

    I think I renewed my subscription for two years in the past mont or so. Did I?
    Bob from Northwest Florida

    Delta P20

  • #2
    Bob,
    PM me your full name, address, etc. and I'll check for you! And if anyone else needs me to check, the offer is open to all of you!

    Bob
    www.GrobetUSA.com

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • will8989
      Reply to My beauties
      by will8989
      He puts biscuts between the long pieces, is that what you meant? He has stainless screws in the lips then puts the plugs on top of that. Scott, cutting one doesn’t take long. It’s the removing of the tiny drill hole, spraying each piece with distilled water, letting dry, sanding and sometimes flap...
      Today, 10:55 AM
    • Rolf
      Reply to Cutting guide for straight cut on a scroolsaw
      by Rolf
      Like Bob said clamp a straight edge to the table and adjust it to compensate for the blade drift. There are some blades that have no or very little drift. Like the Olson PGT series it also seems to me that the Pegas MGT 3 or larger cut very straight....
      Today, 07:54 AM
    • Rolf
      Reply to My beauties
      by Rolf
      I now you do beautiful work but I have to say your attention to details on these baskets is impressive. soft smooth edges, no visible glue squeeze out. And of course the cutting boards are beautiful. I am guessing that Bruce cut a spline in the end of the board and then dowels. I have not seen that...
      Today, 07:49 AM
    • NC Scroller
      Reply to My beauties
      by NC Scroller
      You are one busy lady. About how long does it take to cut one?
      Today, 05:51 AM
    • NC Scroller
      Reply to Hegner Multimax-18 for sale Tucson
      by NC Scroller
      Good luck.
      Today, 05:47 AM
    Working...
    X