No announcement yet.

Fish And Chips

  • Filter
  • Time
  • Show
Clear All
new posts

  • Fish And Chips

    I called my husband and asked if I should pick up fish and chips on my way home from work, but he just grunted.

    I think he still resents letting me choose our twins names.
    There is no opinion, however absurd, which men will not readily embrace as soon as they can be brought to the conviction that it is readily adopted.
    (Schopenhauer, Die Kunst Recht zu Behalten)

  • #2
    LOL ! I miss my fish and chips, Good to see you
    on the forum again!.
    RBI G4 Hawk, Delta SS350, Nova 1624 DVR XP
    Philosophy "I don't know that I can't, therefore I can"
    Proud Member of the Long Island Woodworkers Club
    And the Long Island Scrollsaw Association


    • #3
      AKA Paul from Washington State


      • #4
        My children are Burger and Fries.


        • #5
          Kinda reminds me of the famous twin sisters in Japan named Kin and Gin (pronounced Keen and Geen [similar to green]) with the literal translation of Silver and Gold. One lived to be 107, the other 108 years. They died around 2001 or 2002.

          Of course we have on our shores Diamond and Silk!
          Hank Lee
          Experience is what you get when you don't get what you wanted.


          Unconfigured Ad Widget


          Latest Topics


          • NC Scroller
            Reply to Local craft fair very disappointing.
            NC Scroller
            Sad but seeing this trend more and more. I think there are several reasons. In general fewer people are interested in hand crafted goods made by local artists. They see what they like and buy it no matter if I was hand crafted locally or commercially produced. Second the made overseas stuff is cheaper...
            Today, 07:43 AM
          • WynnD
            Reply to Confused "newbie", here!
            The set screw Carole mentioned is opposite the blade tightening knob. She is correct the screws will make the blade be off center. I had only one problem with the DW. There is a fitting on the end oif the motor arm. Mine came loose and made a racket. I followed the video you mentioned and it was very...
            Today, 06:40 AM
          • handibunny
            Reply to Confused "newbie", here!
            Start by retracting the set screw fully on both upper and lower clamps, then turn them each the same amount until they have protruded enough to grab the blade when you tighten the thumb screw. If for some reason the blade is still not completely perpendicular, adjust them until it is. Should not be...
            Today, 06:08 AM
          • will8989
            Reply to Local craft fair very disappointing.
            A lot of fairs in this area are going back to the way it used to be meaning you need to submit pictures of your work and some equipment. A lot of promoters are also visiting craft shows and talking to vendors and asking them to apply for their show. this is my 3rd year at the howard county 3 day show...
            Today, 12:12 AM
          • cwmagee
            Reply to Confused "newbie", here!
            If my memory is correct you have a set screw on the left side of blade clamp and the thumb screw on the right side on both upper and lower blade clamps. If you do not adjust both set screws so they are the same (just proud of blade clamp slot), your blade will not be square.
            Yesterday, 10:01 PM