Announcement

Collapse
No announcement yet.

Children Learn Early

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Children Learn Early

    Some things speak for themselves. . . .
    Attached Files
    I've Got A Lot More To Learn
    About Leaving Battlegrounds Alone
    "~~ Molly Venter

  • #2
    They sure do.

    george
    A day without sawdust is a day without sunshine.
    George

    delta 650, hawk G426

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • dwssr2
      Reply to hegner 2"
      by dwssr2
      I have no idea what the measurements of the 18" table are, I can give measurements of the poly max and the 14"....
      Today, 05:22 AM
    • MidMich324
      Reply to hegner 2"
      by MidMich324
      Just Wondering...

      Is the table size on the 22" hegner saw as on the 18" hegner saw?

      With the 22" inch one you get 4 more inches of depth of cut but do you also get a few more inches of table?
      Yesterday, 09:30 PM
    • will8989
      Reply to Spring Issue
      by will8989
      I had to fool around with copying and taping a pattern again today. This wasn’t as bad as the fish, but still a pain. I use rapid resizer. Scan a pattern, put in size I want and it prints it out. If more than one page, it numbers each page at the top and I tape them together. Had the fish pattern...
      Yesterday, 09:28 PM
    • millwab
      Reply to Peanuts #1
      by millwab
      Rolf, I cover it with clear contact paper (comes off clean without leaving a residue) and draw a grid for the direction I want to cut (ie horizontal or diagonal) to keep the rows even. The rest is all freehand....
      Yesterday, 02:51 PM
    • Don in Brooklin On
      Reply to Spring Issue
      by Don in Brooklin On
      Rolf

      I use acrobat reader. The poster feature will enlarge and if it goes to multiple pages it will put in cut marks. Even if the page is over letter size it will spread to multiple pages at 100%.

      If it is in PDF form you can open with Inkscape or GIMP and select what you...
      Yesterday, 01:48 PM
    Working...
    X