Announcement

Collapse
No announcement yet.

Let the truth be told.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Let the truth be told.

    Politicians and diapers should be changed often -- and for the same reason.

    John

    Old Dust

  • #2
    AMEN to that.

    Comment


    • #3
      Correction: Politicians need to be changed MORE OFTEN!
      Fred


      There's a fine line between woodworking and insanity, I'm just not sure which side of the line I'm on!

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • axor
        Reply to Shawl pins
        by axor

        Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...
        Today, 03:21 PM
      • handibunny
        Reply to EX dust collection holes screwed up a project.!
        by handibunny
        Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
        Today, 09:21 AM
      • Bill Wilson
        Reply to EX dust collection holes screwed up a project.!
        by Bill Wilson
        I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
        Today, 09:06 AM
      • cwmagee
        Reply to EX dust collection holes screwed up a project.!
        by cwmagee
        Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
        Today, 08:40 AM
      • Rolf
        Reply to EX dust collection holes screwed up a project.!
        by Rolf
        That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
        Today, 07:28 AM
      Working...
      X