Announcement
Collapse
No announcement yet.
Ryobi Carver
Collapse
X
-
Re: Ryobi Carver
CALLYNNE, I HAVE A RYOBI DETAIL CARVER MODEL DC500
HAVENT HAD ANY PROBLEMS WITH IT. ITS ABOUT 3YRS
OLD. ANY WAY I STILL HAVE THE BOOKLET FOR IT.
HERE IS THE ADRESS AND A PHONE #.
RYOBI AMERICA CORP.
5201 PEARMAN DAIRY RD.
ANDERSON, SC. 29625-8950
PHONE - 1-800-525-2579
HOPE THIS HELPS!
-
Re: Ryobi Carver
Sounds like it might need a cleaning and a little lube job (emphasis on little) ... Not having seen one don't know how hard it would be to take apart .... clean the brushes and armatur and a drop of oil on the bearings/bushings and the blade holder mechanism. Shouldn't be too difficult and what do you have to lose, it don't work now.
Comment
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
Reply to Spiral Blades - Tips & Tricks?by RolfI have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...-
Channel: Tools and Blades
Today, 09:16 AM -
-
Reply to Spiral Blades - Tips & Tricks?by JimernThe best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
-
Channel: Tools and Blades
Today, 05:27 AM -
-
Reply to My lucky day!by will8989🍷🍷MD is a cluster mess. Getting the vaccine is fast. Getting the appointment is another story altogether. The county executive makes the rules for their own county. State says 65+ the jerk that runs this county says no, 75+ then puts a whole bunch of people on a priority list. But, there are state...
-
Channel: Off Topic
Yesterday, 09:18 PM -
-
Reply to A few Fretwork projects completed.Excellent cutting and choice of woods. I've made a couple of those classics myself. Thank you for sharing, and pushing me to get busy!
-
Channel: Fretwork and Portraits
Yesterday, 09:17 PM -
Comment