Announcement

Collapse
No announcement yet.

custom woodcarving knives

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • custom woodcarving knives

    Anyone know where or how to get info about Bill Essex custom woodcarving knives? Please email replies direct or post on message board for this site.

  • #2
    Re: custom woodcarving knives

    John,
    You can find Bill's knives here:

    The Tool Box
    Phone: 432-689-9629
    E-mail: [email protected]

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • planeur
      Reply to My covid angel
      by planeur
      Thanks to all !😀 Your comment are very good and make sense!

      My piece is 8"X8" X 1/2" thick.
      I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
      Was it a good idea.....?...
      Today, 09:45 AM
    • Rolf
      Reply to My covid angel
      by Rolf
      Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
      Today, 09:02 AM
    • Rolf
      Reply to Tough Decisions
      by Rolf
      The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
      Today, 08:49 AM
    • NC Scroller
      Reply to My covid angel
      by NC Scroller
      I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
      Today, 07:27 AM
    • Quartz43
      Reply to Tough Decisions
      by Quartz43
      I understand supporting the magazine and agree. I just do not find many projects that fit my desires.

      I would like to see them do a poll with subscribers to find out what type projects people want to see....
      Today, 05:42 AM
    Working...
    X