Despite the name... - Scroll Saw Woodworking and Crafts Message Board

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

X

kerry_nf

Senior Member

Join Date: Nov 2006

Posts: 727
- Share
- Tweet
#1

Despite the name...

02-27-2007, 08:13 PM

I should state for the record...I AM A MAN! LOL!!

Was chatting with another member tonite who thought I was a woman...apparently she lost a bet...HA HA...that cracked me up!

Sorry guys, but alas 'tis true!

Kerry

Check me out on the web:
http://www.kerrysworld.com
Tags: None
JoelM

Work in progress

Join Date: Feb 2007

Posts: 78
- Share
- Tweet
#2

02-27-2007, 09:22 PM

I've seen your website, so there was no confusion here.

Joel
Comment
lucky788scroller

Senior Member

Join Date: Sep 2005

Posts: 6305
- Share
- Tweet
#3

02-27-2007, 09:46 PM

So Kerry.... did you get a date????????????? LOL, just kidding sir! Dale

Dale w/ yella saws
Comment
kerry_nf

Senior Member

Join Date: Nov 2006

Posts: 727
- Share
- Tweet
#4

02-27-2007, 10:05 PM

Bob sent me a few winks...that must have been why. lol

Check me out on the web:
http://www.kerrysworld.com
Comment
kerry_nf

Senior Member

Join Date: Nov 2006

Posts: 727
- Share
- Tweet
#5

02-27-2007, 10:07 PM

Just kiddin' Bob.

Check me out on the web:
http://www.kerrysworld.com
Comment

Previous template Next

Reply to Question about tilting head saws

by Jim Lowder

Thank you everyone. I guess I just need to scroll more and have more patience with my abilities. You all are amazing...
- Channel: Welcome Members
Today, 08:08 PM
Reply to Cutting Air

by evilbadger

How thick is that foam Randy? That turned out really nice.

The view on the house is nice but that 11 foot 3 ceiling height is killing me....
- Channel: General Scroll Saw
Today, 07:56 PM
Reply to Question about tilting head saws

by Rolf

I have both types of saw A tilting table Hawk g426 and an Older Excalibur with a tilting head. Unlike Carole for bevel cuts I prefer the tilting head I do larger projects and it is easier for me.
Regarding compound cuts they are cut at 90 degrees.

If I were in the market for a new...
- Channel: Welcome Members
Today, 05:38 PM
Reply to Question about tilting head saws

by handibunny

If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. 😁

Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
- Channel: Welcome Members
Today, 05:09 PM
Reply to Question about tilting head saws

by Jim Lowder

Thank you all for the info. Sounds like it’s talent or practice issue not my saws. Wife already gave permission to buy a new one. I will wait tho
- Channel: Welcome Members
Today, 04:51 PM

Working...

X