Announcement

Collapse
No announcement yet.

Super Bowl

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Super Bowl

    Way To Go Colts


    Bob
    Delta P-20 & Q-3

    I wondered why the baseball was getting bigger. Then it hit me!

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • axor
    Reply to Shawl pins
    by axor

    Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...
    Today, 03:21 PM
  • handibunny
    Reply to EX dust collection holes screwed up a project.!
    by handibunny
    Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
    Today, 09:21 AM
  • Bill Wilson
    Reply to EX dust collection holes screwed up a project.!
    by Bill Wilson
    I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
    Today, 09:06 AM
  • cwmagee
    Reply to EX dust collection holes screwed up a project.!
    by cwmagee
    Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
    Today, 08:40 AM
  • Rolf
    Reply to EX dust collection holes screwed up a project.!
    by Rolf
    That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
    Today, 07:28 AM
Working...
X