If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I was watching the movie Miracle on 34th Street, the one made in 1947, in the scene where they show the Macy's catalog there was a picture of a scrollsaw. Did anyone else see it.
Bob
Delta P-20 & Q-3
I wondered why the baseball was getting bigger. Then it hit me!
Since I live in Hammond, aka Hohman, Indiana, I'm more of a "Christmas Story" guy. My first wife lived across the street from and went to Warren G. Harding school. When I drove and maintained limousines 20+ years ago I dealt with Jean Shepard's brother Randy.
Here's a story from our local paper about the connections:
The Arizona State Fair is here, and I entered into the fine arts competition in the highly generic category of "Wood Creations", which they in include absolutely everything in wood that's NOT 2D....including carvings, inlay, intarsia, fret, lathe work, furniture, etc ( I have no clue how they...
You do not have permission to view this gallery.
This gallery has 3 photos.
I have had my Bosch Miter Saw since early 2000 and have used them three or four times at the most, That said is this new or is used? I am almost certain that they are available from replacementparts.com unless the saw model has been discontinued
You can find them on ebay for your saw. Like KarlB, I have had my Makita Chop saw since 2010 and used the hold downs maybe three times. They have their purpose. That saw does need a bit of TLC. Check and make sure it is properly setup.
Comment