Announcement

Collapse
No announcement yet.

zone time

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • zone time

    I just happen to noticed that this forum "clock " are 4 hours ahead of mine time zone and I wonder what clock zone are the forum are in

  • #2
    Hi Ray,

    You can set your time zone in the options page (in the bar above the forum select User CP then Edit Options). From the four hour difference I'm guessing that you are in Eastern Daylight Time and the board is set to Universal Time (aka Greenwich Mean Time, which is confusing since the town of Greenwich is an hour off of GMT in the summer).

    Our hosts at Fox Chapel are in Pennsylvania, and we have members world wide.

    --Rob

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • Bill Wilson
      Reply to Tough Decisions
      by Bill Wilson
      Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
      Today, 09:51 AM
    • planeur
      Reply to My covid angel
      by planeur
      Thanks to all !😀 Your comment are very good and make sense!

      My piece is 8"X8" X 1/2" thick.
      I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
      Was it a good idea.....?...
      Today, 09:45 AM
    • Rolf
      Reply to My covid angel
      by Rolf
      Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
      Today, 09:02 AM
    • Rolf
      Reply to Tough Decisions
      by Rolf
      The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
      Today, 08:49 AM
    • NC Scroller
      Reply to My covid angel
      by NC Scroller
      I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
      Today, 07:27 AM
    Working...
    X