Announcement

Collapse
No announcement yet.

Here's another for Jim Mex

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Here's another for Jim Mex

    another Automeris io
    Attached Files
    May the wind at you back .....
    Not be from Lunch.
    Don't take life too seriously; No one gets out alive.

    Beauty is in the eye of the BEERHOLDER

    Visit My Gallery

    Oily's Gallery

    http://www.picturetrail.com/oily11
    Tags: None
  • #2
    Looks almost like it has fur. Nice picture.

    Here is a little ....Did You Know tidbit.

    Montana has one of the largest and most diverse populations of butterflies anywhere in North America. 212 species and still counting. Now you can say "it was worth getting up today". You learned something.
    Last edited by wood-n-things; 06-09-2012, 07:10 PM.
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment

    • #3
      Hey Rob - you sure gets some furry beauties visiting you pal, or is it that they just come fluttering out of your empty wallet when you are searching for dimes?

      Another nice set of snaps.
      Jim in Mexico

      Logic will get you from A to B. Imagination will take you everywhere.
      - Albert Einstein

      Comment

      Previous template Next

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse
      • Bill Wilson
        Reply to Tough Decisions
        by Bill Wilson
        Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
        Today, 09:51 AM
      • planeur
        Reply to My covid angel
        by planeur
        Thanks to all !😀 Your comment are very good and make sense!

        My piece is 8"X8" X 1/2" thick.
        I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
        Was it a good idea.....?...
        Today, 09:45 AM
      • Rolf
        Reply to My covid angel
        by Rolf
        Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
        Today, 09:02 AM
      • Rolf
        Reply to Tough Decisions
        by Rolf
        The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
        Today, 08:49 AM
      • NC Scroller
        Reply to My covid angel
        by NC Scroller
        I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
        Today, 07:27 AM
      View All
      Working...
      X