Announcement

Collapse
No announcement yet.

Happy Birthday--CherieE

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Happy Birthday--CherieE

    Happy Birthday I hope you have a fun filled day!
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

  • #2
    A very Happy Birthday Cherie!!
    Frieke
    www.friewoodart.webs.com

    Visit Frieke's gallery

    Don't let the pain of your past and the fear of your future ruin the happiness of your present.

    Comment


    • #3
      Hi Cherie, haven't been on much lately sorry to miss your Birthday. Hope you had a great day.
      Dennis

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • hotshot
        Reply to Darkening oak
        by hotshot
        I've had very good luck using the oven. The wood does soften, but with oak, that usually isn't a problem. It also darkens all the way through.

        He is a flash from the past where I show some puzzle boxes made with oven darkened oak.

        https://forum.scrollsawer.com/forum/...2-...
        Today, 12:32 AM
      • Misouri Wayne
        Reply to Spiral Blades - Tips & Tricks?
        by Misouri Wayne
        Thanks for the post. I have tried spirals in the past and had lots of issues. I need to set down one day and keep cutting with them until I get the hang of it. Part of my problem may have been covered by your number 7. Tried pine thinking it would be easy to cut but now realize the grain may have...
        Yesterday, 07:05 PM
      • Sandy Oaks
        Reply to Eagle
        by Sandy Oaks
        I agree, a beautiful piece and wonderful cutting. Years ago, my father had Alzheimer. The last six months we had him in the VA center in St. Cloud MN. His wood work shop is still in MN. I could not take it down to TN....
        Yesterday, 12:00 PM
      • Rolf
        Reply to Spiral Blades - Tips & Tricks?
        by Rolf
        I have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
        They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...
        Yesterday, 09:16 AM
      • Jimern
        Reply to Spiral Blades - Tips & Tricks?
        by Jimern
        The best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
        Yesterday, 05:27 AM
      Working...
      X