Announcement
Collapse
No announcement yet.
a dog story.
Collapse
X
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
by handibunnyRolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
-
Channel: Tools and Blades
Today, 09:21 AM -
-
by Bill WilsonI've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
-
Channel: Tools and Blades
Today, 09:06 AM -
-
by cwmageeCarole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
-
Channel: Tools and Blades
Today, 08:40 AM -
-
by RolfThat is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
-
Channel: Tools and Blades
Today, 07:28 AM -
-
by handibunnyJust a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
-
Channel: Tools and Blades
Today, 06:21 AM -
Comment