Announcement

Collapse
No announcement yet.

Frieke and jim_mex's Easter collaboration project

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Frieke and jim_mex's Easter collaboration project

    Ok, this is a bit of a teaser but since some folks who may check in on this section don't necessarily check in on all other sections of the forum please go to

    http://www.scrollsawer.com/forum/bow...htm#post403624

    to see what Frieke and myself conjured up as our joint collaboration project during my Easter visit to her place in Belgium.

    I wasn't quite sure where to stick this project, so as to speak, but as it isn't really a toy but an ornamental piece I placed it in the 3D section.

    For those folks still waiting to see some photos of my visit and of Frieke'e workshop I'll sort them out as soon as I get over the jet-lag after flying home to Mexico from Italy early next week. Apologies for the delay.

    Please leave any comments regarding the project in the other thread.

    Thanks!

    Jim
    Last edited by jim_mex; 04-26-2012, 06:19 PM.
    Jim in Mexico

    Logic will get you from A to B. Imagination will take you everywhere.
    - Albert Einstein

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • tgiro01
    Reply to I admit it... I splurged on a new "toy"
    by tgiro01
    One issue I found with the insert that comes with the saw was the areas they smoothed for the kickback pawls. If the insert is leveled correctly, those areas are sitting about 1/32-inch below the table. I had a problem with some small pieces getting caught and jamming because of that. Sawstop's recommendation...
    Today, 08:18 AM
  • Rolf
    Reply to Interesting pallet
    by Rolf
    That is a definit rescue for a special project. I rarely get or use any pallet wood. But did use some from the pallet that my drill press was on. It looked like pine but was was very hard, carefully checked for nails and ran it through the drum sander with some 80 grit to get rid of any small grit.
    Today, 08:16 AM
  • Quartz43
    Reply to Carved Fretwork Pumpkin
    by Quartz43
    I wish I could post the video as it looks better with the lights blinking. I used some red clear plastic behind the eyes and nose. It was a fun project.
    Yesterday, 07:29 PM
  • Linda In Phoenix
    Reply to Interesting pallet
    by Linda In Phoenix
    Maybe a star shining to tell us something? That piece of wood is a very special piece! Good eye.
    Yesterday, 07:27 PM
  • Misouri Wayne
    Reply to Bruce, the one on probation
    by Misouri Wayne
    Tough situation. Just have to take it one day at a time.
    Yesterday, 04:55 PM
Working...
X