If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Try to add a first name to your signature, it's nicer.
Where are you located, how long have you been scrolling, what saw do you use, what do you like...?
Tell us a little about yourself
Regards,
Marcel
http://marleb.com
DW788. -Have fun in the shop or it isn't a hobby anymore. NOTE: No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.
I haven't posted in a few months but I have been keeping up. I agree with what Mark is saying. To make everything for everyone would be very difficult. And I understand (from my wife's perspective) that computer apps are totally made for nerds - in her opinion. The breakdown is often between two of...
Yes I'm still using the one I built I did some upgrades to it though. I swapped out the pipes for linear motion rails and made the gantry out of aluminum. I guess if I were to upgrade now I would be looking for a full size machine that could do 4x8 sheets of plywood with an automatic tool changer but...
With all these new tool stories, I was working on and old one. About 9 years ago, I built a router table. Then, before it was finished, I had to start using it. And I have used it over the years. A couple of months ago, While I was contemplating cleaning, I looked at the machine and decided to finish...
Comment