Announcement

Collapse
No announcement yet.

Wishing well lamp

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Wishing well lamp

    does anyone know what type of clear coat I could use for the lamp shade itself? I'm not sure how hot the bulb will get and am in need of something that might be heat resistant,
    Last edited by DukeNukem; 02-25-2012, 05:06 PM.
    Don't worry be scrolling

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • Rolf
    New Toy!
    by Rolf
    A family friends father passed away and he was an avid bird carver. So my nephew is helping the family sell some of his tools. I bought this air cleaner and will b uy most of his carving knives and burrs. And no that is not my workshop! Not even close. ...
    Today, 04:47 PM
  • Rolf
    Reply to EX dust collection holes screwed up a project.!
    by Rolf
    I just did a quick job on my table. Charles Hand has noticed that the adhesive on the new rolls of Contact brand shelf paper leaves a residue. He has changed to The duck brand. I just bought a roll and covered my table with it. It is a tough slick surface. It will be interesting to see how it holds...
    Today, 04:44 PM
  • axor
    Reply to Shawl pins
    by axor

    Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...
    Today, 03:21 PM
  • handibunny
    Reply to EX dust collection holes screwed up a project.!
    by handibunny
    Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
    Today, 09:21 AM
  • Bill Wilson
    Reply to EX dust collection holes screwed up a project.!
    by Bill Wilson
    I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
    Today, 09:06 AM
Working...
X