Announcement

Collapse
No announcement yet.

Jediscroller

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Jediscroller
    replied
    Oooops.....just call me scatterbrained. Sorry about that Bruce. I'll be working on it this week and will also get back to you with some comments.

    Leave a comment:

  • millwab
    started a topic Jediscroller

    Jediscroller

    Hey Kevin,
    Have you glanced at your PMs lately? Haven't heard back and didn't know if you read them yet or not (don't worry about the one about the Open House ).

    Bruce
    Tags: None
Previous template Next

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse
  • Eugene Downes
    Reply to Stack Cutting
    by Eugene Downes
    I had considered useing a hot glue gun but I like to be able to reuse some of the bigger waste pieces. Also when I use brads and they extend through the bottom piece I am always carefull to take a small hammer and tap the points back up flush with the bottom piece so I do not scratch the table.
    Today, 03:29 PM
  • wjbclocks1
    Reply to Stack Cutting
    by wjbclocks1
    I use a hot glue gun. all around the edges, No chance of scrathing thhe table/
    Today, 10:07 AM
  • Rolf
    Reply to Scrollsaws
    by Rolf
    Ray at Seyco has the parts for the Excaliburs as long as it isn't one of the more recent Chinese clones....
    Today, 07:15 AM
  • Rolf
    Reply to Stack Cutting
    by Rolf
    I use a pin nailer in the waste areas. The brad and pin nail guns are a wonderful thing.
    Today, 07:11 AM
  • eric_h_e
    Reply to Stack Cutting
    by eric_h_e
    Good idea. I’ll have to try that when I get to the point of stack cutting. 👍
    Yesterday, 09:09 PM
View All
Working...
X