Announcement

Collapse
No announcement yet.

Anyone Have Gun Cabinet Plans?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Anyone Have Gun Cabinet Plans?

    I know that this is not scrolling but I am looking for some gun cabinet plans. It will have some scrolling incorporated into the cabinet as decorations though. Thanks. Steve
    If This HillBilly Can't Fix it Then it Ain't Broke!!!
    My Gallery
    [email protected]

  • #2
    Just look for free woodworking plan and go to woodworkersworkshop.com theyhave plenty of projects hope this helps.Jerry
    Don't worry be scrolling

    Comment


    • #3
      Woodsmith has a couple of dandy gun cabinet plans.


      Jan

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • handibunny
        Reply to EX dust collection holes screwed up a project.!
        by handibunny
        Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
        Today, 09:21 AM
      • Bill Wilson
        Reply to EX dust collection holes screwed up a project.!
        by Bill Wilson
        I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
        Today, 09:06 AM
      • cwmagee
        Reply to EX dust collection holes screwed up a project.!
        by cwmagee
        Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
        Today, 08:40 AM
      • Rolf
        Reply to EX dust collection holes screwed up a project.!
        by Rolf
        That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
        Today, 07:28 AM
      • handibunny
        Reply to EX dust collection holes screwed up a project.!
        by handibunny
        Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
        Today, 06:21 AM
      Working...
      X