Announcement

Collapse
No announcement yet.

Don't Mess w/ Texas . . . . better make that North Carolina!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Don't Mess w/ Texas . . . . better make that North Carolina!

    Caught On Tape: Clerk Punches, Knocks Out Armed Robber - Greenville News Story - WYFF Greenville

    Worth the read!

    Go North Carolina!!

    John
    I've Got A Lot More To Learn
    About Leaving Battlegrounds Alone
    "~~ Molly Venter

  • #2
    Like this the bad guy went down ..................
    Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

    Comment


    • #3
      Makes you feel good to see the bad guy get it so well. Good shot.
      Pacifism is great, as long as everyone is participating.



      StephenD


      The Southern Arizona Woodturners Association
      Desert Woodcrafters
      Grandpa for the 7 most amazing children.

      Comment


      • #4
        We NC Folks can take care of our selves. Thanks for the story.
        Scott
        Creator of fine designer sawdust.

        Comment


        • #5
          Anybody who would go in there and mess with THAT guy anyway has to be an idiot. Look at that guy. You can tell he can take care of himself.

          That is so funny....making him clean up his own blood. They need to throw him under the jail and throw away the key.

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • hotshot
            Reply to Darkening oak
            by hotshot
            I've had very good luck using the oven. The wood does soften, but with oak, that usually isn't a problem. It also darkens all the way through.

            He is a flash from the past where I show some puzzle boxes made with oven darkened oak.

            https://forum.scrollsawer.com/forum/...2-...
            Today, 12:32 AM
          • Misouri Wayne
            Reply to Spiral Blades - Tips & Tricks?
            by Misouri Wayne
            Thanks for the post. I have tried spirals in the past and had lots of issues. I need to set down one day and keep cutting with them until I get the hang of it. Part of my problem may have been covered by your number 7. Tried pine thinking it would be easy to cut but now realize the grain may have...
            Yesterday, 07:05 PM
          • Sandy Oaks
            Reply to Eagle
            by Sandy Oaks
            I agree, a beautiful piece and wonderful cutting. Years ago, my father had Alzheimer. The last six months we had him in the VA center in St. Cloud MN. His wood work shop is still in MN. I could not take it down to TN....
            Yesterday, 12:00 PM
          • Rolf
            Reply to Spiral Blades - Tips & Tricks?
            by Rolf
            I have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
            They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...
            Yesterday, 09:16 AM
          • Jimern
            Reply to Spiral Blades - Tips & Tricks?
            by Jimern
            The best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
            Yesterday, 05:27 AM
          Working...
          X