Announcement

Collapse
No announcement yet.

Next year's gift from BIL

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Next year's gift from BIL

    So there we were at my brother in law's last night. After everyone opened the baskets & boxes I made and ornaments hubby turned, my sweek BIL said next year he was giving everyone something made out of 2x4's. Hubby jumped right in and said "We'll take a new workshop in the backyard."!!!! Let's see if he delivers!!!
    Betty

    "Congress needs to realize it is a government of the people, by the people and for the people. Not of the people, by the people and for Congress." - Dr. Benjamin Carson, Pediatric Neurosurgeon, Johns Hopkins Hospital

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • handibunny
    Reply to EX dust collection holes screwed up a project.!
    by handibunny
    Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
    Today, 09:21 AM
  • Bill Wilson
    Reply to EX dust collection holes screwed up a project.!
    by Bill Wilson
    I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
    Today, 09:06 AM
  • cwmagee
    Reply to EX dust collection holes screwed up a project.!
    by cwmagee
    Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
    Today, 08:40 AM
  • Rolf
    Reply to EX dust collection holes screwed up a project.!
    by Rolf
    That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
    Today, 07:28 AM
  • handibunny
    Reply to EX dust collection holes screwed up a project.!
    by handibunny
    Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
    Today, 06:21 AM
Working...
X