Announcement

Collapse
No announcement yet.

Happy Birthday---Messman

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Happy Birthday---Messman

    Happy Birthday I hope you have a fun filled day!
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

  • #2
    Happy Birthday!!!!! Have a lot of fun and eat cake.

    Jan

    Comment


    • #3
      Thank you very much I plan on enjoying my day
      CHRIS


      http://www.members.cox.net/messman123/messman.htm

      Comment


      • #4
        Happy Birthday Chris.

        Dan

        Comment


        • #5
          Happy Birthday Chris.
          Have a great day.

          Bob
          Delta P-20 & Q-3

          I wondered why the baseball was getting bigger. Then it hit me!

          Comment


          • #6
            Again thanks everyone for the happy birthday wishes
            CHRIS


            http://www.members.cox.net/messman123/messman.htm

            Comment

            Unconfigured Ad Widget

            Collapse

            Latest Topics

            Collapse

            • handibunny
              Reply to EX dust collection holes screwed up a project.!
              by handibunny
              Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
              Today, 09:21 AM
            • Bill Wilson
              Reply to EX dust collection holes screwed up a project.!
              by Bill Wilson
              I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
              Today, 09:06 AM
            • cwmagee
              Reply to EX dust collection holes screwed up a project.!
              by cwmagee
              Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
              Today, 08:40 AM
            • Rolf
              Reply to EX dust collection holes screwed up a project.!
              by Rolf
              That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
              Today, 07:28 AM
            • handibunny
              Reply to EX dust collection holes screwed up a project.!
              by handibunny
              Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
              Today, 06:21 AM
            Working...
            X