Announcement

Collapse
No announcement yet.

Happy Birthday....KarlB

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Happy Birthday....KarlB

    Happy Birthday hope you have a wonderful day!
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

  • #2
    Well I appreciate the sentiments.

    Every birthday reminds me of the line from the Tennessee Ernie Ford song which goes: "...another day older and deeper in debt. St. Peter don't call me cause I can't go...". (Most could finish with the rest of the song. )

    Big 5-0 this year!

    Karl
    Karl in Sunny Southwest Florida

    Comment


    • #3
      Happy belated birthday Karl. Hope you had a wonderful day!
      Dan in So.Ca.

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • Bill Wilson
        Reply to Tough Decisions
        by Bill Wilson
        Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
        Today, 09:51 AM
      • planeur
        Reply to My covid angel
        by planeur
        Thanks to all !😀 Your comment are very good and make sense!

        My piece is 8"X8" X 1/2" thick.
        I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
        Was it a good idea.....?...
        Today, 09:45 AM
      • Rolf
        Reply to My covid angel
        by Rolf
        Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
        Today, 09:02 AM
      • Rolf
        Reply to Tough Decisions
        by Rolf
        The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
        Today, 08:49 AM
      • NC Scroller
        Reply to My covid angel
        by NC Scroller
        I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
        Today, 07:27 AM
      Working...
      X