If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hay has anyone seen Tom, gosh I hope he is not glued to his shop. and haven't heard from Chuck for a while eather. hope they are doing ok. miss them. Tom hows your cost town doing. your old frined Evie miss you
An Alex Fox Pattern C-03. I enlarged the pattern by 30% to fit 1/4" Baltic Birch plywood 10" square. Cut on the Pegas Scroll Saw using Pegas #1 MGT blades. Entry holes drilled with Grobet #68 HSS Twist Drill Bits. Finish is two coats spray Lacquer Clear Gloss with sanding on the Mac Mop between...
I also enjoy making these. I have also used the profiles to turn some on the lathe. I mostly use a 220 Mac mop I have a 180 for the harder woods and then finish with the 220. I do all sanding before assembly.
Leave a comment: