If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hay has anyone seen Tom, gosh I hope he is not glued to his shop. and haven't heard from Chuck for a while eather. hope they are doing ok. miss them. Tom hows your cost town doing. your old frined Evie miss you
Sometimes a person just can't find a good pattern to cut a picture so they have to just make their own. Thats me setting on the running board, the picture was taken about 1973 just before I retired from the Military 1974. After I retred I drove that truck from Pensacola, Florida to Salida, Colorado...
Like most of you out there I like to stack cut because I can finish more than 1 at a time. I've tried many ways in the past to hold everything together. I've used screws, hammer and nails, staples and clamps. The best and easyest way I have found is to use a brad gun. It leaves a very small hole and...
I built these many years ago using scrap 1 inch and 2x4. Drilled as many holes as needed for tjhe different sized blades I used. It has always worked great for me and I don't have any trouble finding the blades....
Search for a used hegner. Parts are readily available and their service Dept is top notch. My first one was a craftsman and hubby bolted it to the workbench it was on. Then I switched to a bandsaw than my Hegner 21 years ago....
Tweet
Comment