If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
http://marleb.com
DW788. -Have fun in the shop or it isn't a hobby anymore. NOTE: No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.
I don't mind the jokes - I don't need to fuss because I know the spirit you posted them- I didn't see anything wrong with them- i even laughed.
Sharon -Just don't get explixit PLEASE
I have both types of saw A tilting table Hawk g426 and an Older Excalibur with a tilting head. Unlike Carole for bevel cuts I prefer the tilting head I do larger projects and it is easier for me.
Regarding compound cuts they are cut at 90 degrees.
If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. ๐
Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
Comment