No announcement yet.

New Pattern/Project Computer Program

  • Time
  • Show
Clear All
new posts

  • New Pattern/Project Computer Program

    Those of you who are familiar with the "MeonaPumpkin" computer software may be aware already that Carving Technologies has come up with a new software package called "Coyote" that allows the scroll sawyer easily make project patterns for both fretwork and intarsia designs. It is a bit costly ($79.95), but makes photo to pattern conversion so easy that even I can do it. Since someone is always asking for such software, I thought I would mention that I have started using it. For those not familiar with the older software, you might check it out at
    Old Mooner

Unconfigured Ad Widget


Latest Topics


  • will8989
    by will8989
    Are you ok Rolf?
    Yesterday, 05:43 PM
  • Jim McDonald
    Reply to About ornament exchange
    by Jim McDonald
    Dave, I will participate. Thanks for doing this again.
    Yesterday, 09:10 AM
  • Rolf
    Reply to Testing this blower motor
    by Rolf
    Without the complete schematic it is hard to know what is correct.
    That said, it is a multispeed blower that obviously has a controller board. That board varies the power to the motor. By doing what you did you bypassed that. You put power across the low and high windings. If any thing connecting...
    Yesterday, 07:43 AM
  • evilbadger
    Reply to Testing this blower motor
    by evilbadger
    If he connected to red and black and the motor spun wouldn't that indicate the motor is grounded? Without connecting the white the circuit isn't complete and the motor should not spin.
    Yesterday, 06:40 AM
  • cwmagee
    Reply to Testing this blower motor
    by cwmagee
    The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.

    You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
    09-28-2023, 08:41 PM