Ohio Club? - Scroll Saw Woodworking and Crafts Message Board

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

X

Pulladigm

Junior Member

Join Date: Jul 2005

Posts: 1
- Share
- Tweet
#1

Ohio Club?

07-19-2005, 01:16 PM

I am a retired, I winter in Baldwin County, Alabama and Summer in Tuscrawas County, Ohio. Can anyone tell me if there are any wood crafting or woodcarving clubs in any of these areas.
Thanx.
Pulladigm ~;^}>
Tags: None
ZooZoo1
- Share
- Tweet
#2

03-30-2006, 03:50 PM

hey hi, where is Tuscrawas county? By what town?
Comment
Neal Moore

Senior Member

Join Date: Mar 2005

Posts: 1046
- Share
- Tweet
#3

03-30-2006, 08:28 PM

It's about halfway up I77 between Cambridge and New Philadelphia...... I think!!!

If it don't fit, don't force it....get a bigger hammer!!
Comment
ZooZoo1
- Share
- Tweet
#4

04-12-2006, 07:09 AM

zoozoo1

Neal, I am over on the other side between Dayton and Lima on I75
Comment
Grizz
- Share
- Tweet
#5

04-12-2006, 08:58 AM

Originally posted by ZooZoo1

Neal, I am over on the other side between Dayton and Lima on I75

Toby, You have gotten further away....
Comment
ZooZoo1
- Share
- Tweet
#6

04-15-2006, 04:48 PM

Grizz, sorry , not really that far am I? Toby
Comment

Previous template Next

Reply to Work in Progress. What is with FOX publishing?

by Don in Brooklin On

Rolf

I do not have any section of 8 1/2 x 11.

I only have the one big document. The size is 31 x 21.5 inches. If I use poster option I can print on 12 pages. I just need one pattern at a time.

I like the way it was done in with previous DVD like 48. Each pattern...
- Channel: General Scroll Saw
Today, 02:14 PM
Reply to Work in Progress. What is with FOX publishing?

by will8989

I still don’t understand why they don’t put the patterns on disc or thumb drives. If they are afraid of them being passed around, a lot are already on Pinterest with the copyright logo on the pattern! I’m not spending money for the magazine cds I already have them. Don’t need the magazine, just...
- Channel: General Scroll Saw
Today, 11:50 AM
Reply to Old Tool - Reborn

by RJweb

Very nice setup, RJ...
- Channel: Tools and Blades
Today, 10:20 AM
Reply to Work in Progress. What is with FOX publishing?

by Rolf

Jim, you made me curious so I did a copy and paste.

This is a test of copy and paste from my MS word....
- Channel: General Scroll Saw
Today, 10:13 AM
Reply to Old Tool - Reborn

by Rolf

Tony great Job! I had all good intentions of building a setup like that but got lazy. Lots of storage on yours and the router lift really is a must have in my opinion. It makes setup so much easier.
What did you use to make your box joints?...
- Channel: Tools and Blades
Today, 10:04 AM

Working...

X