No announcement yet.

Carving Tools in Grizzly catalog?!

  • Time
  • Show
Clear All
new posts

  • Carving Tools in Grizzly catalog?!

    Hi All

    I have seen some interesting sets of carving tools in the most recent Grizzly Tool catalog. One set is a 12 piece set made for Grizzly(it has the Grizzly mark on them dont know the manufacturer) I was wondering if anyone on the board has ever tried any of these carving tools? They also carry some Robert Sorby(?) carving tools for hand carving as well as mallet carving tools?

    That's all for now...

    "let the chips fly!"

Unconfigured Ad Widget


Latest Topics


  • will8989
    by will8989
    Are you ok Rolf?
    Yesterday, 05:43 PM
  • Jim McDonald
    Reply to About ornament exchange
    by Jim McDonald
    Dave, I will participate. Thanks for doing this again.
    Yesterday, 09:10 AM
  • Rolf
    Reply to Testing this blower motor
    by Rolf
    Without the complete schematic it is hard to know what is correct.
    That said, it is a multispeed blower that obviously has a controller board. That board varies the power to the motor. By doing what you did you bypassed that. You put power across the low and high windings. If any thing connecting...
    Yesterday, 07:43 AM
  • evilbadger
    Reply to Testing this blower motor
    by evilbadger
    If he connected to red and black and the motor spun wouldn't that indicate the motor is grounded? Without connecting the white the circuit isn't complete and the motor should not spin.
    Yesterday, 06:40 AM
  • cwmagee
    Reply to Testing this blower motor
    by cwmagee
    The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.

    You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
    09-28-2023, 08:41 PM