used micro-motor/handpiece

Join Date: May 2021

Posts:
- Share
- Tweet
#1

used micro-motor/handpiece

04-29-2002, 06:45 PM

Hi Everybody,
I am new in this wood carving business and I am looking for a used or a reasonably priced equipment.Would appreciate if somebody could help me with this info.Thanks
Tags: None
Rando
- Share
- Tweet
#2

04-29-2002, 08:00 PM

Re: used micro-motor/handpiece

Hey Sam,
If you don't want to lay down all that money for a Foredom,
check out a Dremel. I have a multi-speed with a flex shaft
attachment. Works great, and alot cheaper than the Foredom.
Comment

Previous template Next

Reply to Tough Decisions

by Bill Wilson

Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
- Channel: Publisher Feedback
Today, 09:51 AM
Reply to My covid angel

by planeur

Thanks to all !😀 Your comment are very good and make sense!

My piece is 8"X8" X 1/2" thick.
I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
Was it a good idea.....?...
- Channel: New Scroll Saw Patterns or Designs
Today, 09:45 AM
Reply to My covid angel

by Rolf

Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
- Channel: New Scroll Saw Patterns or Designs
Today, 09:02 AM
Reply to Tough Decisions

by Rolf

The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
- Channel: Publisher Feedback
Today, 08:49 AM
Reply to My covid angel

by NC Scroller

I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
- Channel: New Scroll Saw Patterns or Designs
Today, 07:27 AM

Announcement

used micro-motor/handpiece

Comment

Unconfigured Ad Widget

Latest Topics