Router Question??

Re: Router Question??

The problem you are having might be that you are trying to make to deep of a cut. If you make many shallow cuts rather than one deep cut it many take care of the problem. Another thing you might check is weather you have a bit with a bearing guide or just a fixed stud guide. I hope this helps.

Re: Router Question??

it's been my experience that moving your router
too slowly will cause the burn marks.

I made a frame for a relief carving I did and I wanted to set in the relief in the back side of the frame. I routed a groove in the back and the router seemed to burn the wood alot. I haven't had that much experience routing wood. Is that typical?? I wanted to dress up the front side of the frame but left it smooth, fearing random burn marks on the wood. Is my bit to dull? Any comments are appreciated. Skratch