Announcement

Collapse
No announcement yet.

votive holder pattern error

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • votive holder pattern error

    In preparing to cut the stacked floral votive holder by Michael Riffel in the spring 2018 issue, I found that the pattern piece in the pull out section that had the printing in it was almost 1/8" too small for a two inch forstner bit. By enlarging it 106 % it now had the correct size (2") hole and now became the bottom piece of the votive holder. The piece on page 41 marked base, now became the next to the bottom piece.
    George
    Last edited by sawdustus; 02-20-2018, 11:23 AM.
    A day without sawdust is a day without sunshine.
    George

    delta 650, hawk G426

  • #2
    Thanks for the heads up, George. We'll get a corrected pattern posted.
    www.GrobetUSA.com

    Comment


    • #3
      Here's a corrected pattern for the base.
      Attached Files
      www.GrobetUSA.com

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      Working...
      X