Announcement

Collapse
No announcement yet.

Scrollers Galleries...

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Scrollers Galleries...

    I don't know how I do it...but the last few time I've uploaded 2 of the same pictures and they always go where I don't want them to go...

    HEY ROB, I it did it again..could you please delite one of the Hank pictures that I put in the segmentation section for me and then put the other one in the Intarsia section...

    Thanks
    Trout
    Hawk G-4 Jetcraft
    Fish are food, not friends!
    Tags: None
  • #2
    Please check to make sure I got it right.

    Comment

    • #3
      Thank you...

      I'll try to be more carefull next time...

      thank you again..
      Trout
      Last edited by Trout; 12-10-2006, 11:42 PM.
      Hawk G-4 Jetcraft
      Fish are food, not friends!

      Comment

      Previous template Next

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse
      • handibunny
        Reply to Question about tilting head saws
        by handibunny
        If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. 😁

        Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
        Today, 05:09 PM
      • Jim Lowder
        Reply to Question about tilting head saws
        by Jim Lowder
        Thank you all for the info. Sounds like it’s talent or practice issue not my saws. Wife already gave permission to buy a new one. I will wait tho
        Today, 04:51 PM
      • hotshot
        Reply to Question about tilting head saws
        by hotshot
        I'll talk about this specific "slice" of your question, with more detail that you probably want or need.

        Most Tilting head saws do come from the same Taiwan factory, except Excalibur. So what happened with Excalibur was . . . General got bought by a Chinese investor, some China/Taiwan...
        Today, 04:41 PM
      • Linda In Phoenix
        Reply to Basket C15
        by Linda In Phoenix
        Did this thread get hacked? That is a very strange sidetrack from KyivWorkshop.
        Today, 04:21 PM
      • handibunny
        Reply to Question about tilting head saws
        by handibunny
        It doesn’t matter whether the saw table tilts or the saw arm tilts. Either can be used for any project cut at an angle, and there’s a learning curve for each.

        I actually prefer the tilting table because the blade remains vertical. I find that at really steep angles, like 40 or 45 degrees,...
        Today, 02:10 PM
      View All
      Working...
      X