Announcement

Collapse
No announcement yet.

Joining the message board

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Joining the message board

    We're making some changes to the message board to try to keep out some of the spam. Most of you don't see it, but the Moderators spend a lot of time checking on potential spammers, deleting spam, and working hard to keep this board clean.

    We're trying an update that will hopefully cut down on some of the spam. New members' posts may be moderated for the first few times (the mods are on here a lot and will be able to approve them quickly) but after a few posts, you will be able to post freely.

    So if you are a new member, and your post doesn't show up right away, wait a bit, and it probably will.

    Bob Duncan
    Technical Editor
    www.GrobetUSA.com

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • handibunny
    Reply to EX dust collection holes screwed up a project.!
    by handibunny
    Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
    Today, 09:21 AM
  • Bill Wilson
    Reply to EX dust collection holes screwed up a project.!
    by Bill Wilson
    I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
    Today, 09:06 AM
  • cwmagee
    Reply to EX dust collection holes screwed up a project.!
    by cwmagee
    Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
    Today, 08:40 AM
  • Rolf
    Reply to EX dust collection holes screwed up a project.!
    by Rolf
    That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
    Today, 07:28 AM
  • handibunny
    Reply to EX dust collection holes screwed up a project.!
    by handibunny
    Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
    Today, 06:21 AM
Working...
X