Announcement

Collapse
No announcement yet.

Do you have anywhere where I can show some of my Router / Engraved Designwork?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Do you have anywhere where I can show some of my Router / Engraved Designwork?

    Search as I might through this site, I cannot seem to find a suitable location for some of my Aussie designs which are done with my 1/4" Router, and a Dremel attached to a router-base, & fitted with a 1/8" engraving tip.
    Any helpful suggestions ?

  • #2
    Hi Roger,
    If they're not scroll sawing, per sey, I'd put them in the Off Topic area. If they're more carving than scrolling, we've got an entire message board for carving at
    Woodcarving Illustrated Message Board

    Best Regards,
    Bob Duncan
    Technical Editor
    www.GrobetUSA.com

    Comment


    • #3
      Put them in the "Off Topic" section Roger. We would love to see them.
      Mick
      I am always ready to learn although I do not always like being taught. Winston Churchill

      Comment


      • #4
        Thanks guys,- have placed photos in " Off Topic." Section

        Thank you for your assistance. Have placed editorial content about what I have been doing, along with the basic descriptions of three Router-cut signs I have recently done, and their accompanying photos in the, " Off Topic," section.
        Got heaps more photos, most of which are on my new specialized website for my Wooden Signs.

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • Misouri Wayne
          Reply to My puffin coming home....
          by Misouri Wayne
          Nice combination of different art forms.
          Thanks for sharing.
          Today, 05:02 PM
        • Quartz43
          Reply to My lucky day!
          by Quartz43
          My wife and I got the Moderna vaccine with our second shot last week. We had no reaction after the first shot but both of us had some body and fatigue for two days after the 2nd dose.
          Today, 04:44 PM
        • JeffieK
          Reply to My lucky day!
          by JeffieK
          Here in Mid-Michigan, my wife & I (both 65) got our first shot - the Pfizer one - last Sunday; with our second one scheduled for March 21st. Both of us were a little fatigued that evening... went to be early. Next day, just had a sore arm where we received the shot. Hope it's that way with the second...
          Today, 03:49 PM
        • planeur
          My puffin coming home....
          by planeur
          My first creation in intarsia , with a gift from my sister of that little puffin in stained glass. After couple of tests , I created this frame , as in my blue heron, and put the puffin leaving the water and waves, between rocks and with a look to his smiling rock mounster, on a beautiful sunset....
          Today, 11:16 AM
        • vgraf
          Reply to What do you think?
          by vgraf
          I have a VacuFlo system for my house. It might have enough suction for a small table saw but not for the large cabinet makers saw like you have.

          Like the others have said, your Walvac might work fine for smaller tools, especially for a hand sander.

          The VacuFlo actually uses...
          Today, 02:20 AM
        Working...
        X