Announcement

Collapse
No announcement yet.

Posting times?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Posting times?

    What time zone is forum in?
    Rolf
    RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
    Philosophy "I don't know that I can't, therefore I can"
    Proud Member of the Long Island Woodworkers Club
    And the Long Island Scrollsaw Association

  • #2
    Methinks PD(S)T or it could be your local time.
    Sawdust King

    If there is one thing I can make perfect every time it is sawdust.

    Comment


    • #3
      It is 4 hours later than EDT. that makes me think Iceland
      Rolf
      RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
      Philosophy "I don't know that I can't, therefore I can"
      Proud Member of the Long Island Woodworkers Club
      And the Long Island Scrollsaw Association

      Comment


      • #4
        I have No clue. lol. but you can post anytime. your friend Evie

        Comment


        • #5
          Rolf:
          If you look at the footer of the "User CP" screens it is stated that All times are in GMT-4 .
          Go to
          http://wwp.greenwichmeantime.com/ to have GMT better defined.

          The forum times that are displayed on your screens are converted to your local times. I am the Eastern Time zone and the GMT-4 agrees with my current time displayed.

          Hope this helps.

          Bob
          Scrolling satisfies the passion for intricate creativity. My saw is an Excalibur EX21.

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • Eugene Downes
            Reply to Stack Cutting
            by Eugene Downes
            I had considered useing a hot glue gun but I like to be able to reuse some of the bigger waste pieces. Also when I use brads and they extend through the bottom piece I am always carefull to take a small hammer and tap the points back up flush with the bottom piece so I do not scratch the table.
            Today, 03:29 PM
          • wjbclocks1
            Reply to Stack Cutting
            by wjbclocks1
            I use a hot glue gun. all around the edges, No chance of scrathing thhe table/
            Today, 10:07 AM
          • Rolf
            Reply to Scrollsaws
            by Rolf
            Ray at Seyco has the parts for the Excaliburs as long as it isn't one of the more recent Chinese clones....
            Today, 07:15 AM
          • Rolf
            Reply to Stack Cutting
            by Rolf
            I use a pin nailer in the waste areas. The brad and pin nail guns are a wonderful thing.
            Today, 07:11 AM
          • eric_h_e
            Reply to Stack Cutting
            by eric_h_e
            Good idea. I’ll have to try that when I get to the point of stack cutting. 👍
            Yesterday, 09:09 PM
          Working...
          X