Announcement

Collapse
No announcement yet.

Strange thing Happened when uploading a photo

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Strange thing Happened when uploading a photo

    I uploaded my latest cutting (The Den) but instead of going into my album (my attempts) it ended up in it's own album.
    Is there anyway to move it to my album???
    Thanks,

    Kevin
    Kevin
    Scrollsaw Patterns Online
    Making holes in wood with an EX-30, Craftsman 16" VS, Dremel 1680 and 1671
    Tags: None
Previous template Next

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse
  • Bill Wilson
    Reply to Tough Decisions
    by Bill Wilson
    Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
    Today, 09:51 AM
  • planeur
    Reply to My covid angel
    by planeur
    Thanks to all !😀 Your comment are very good and make sense!

    My piece is 8"X8" X 1/2" thick.
    I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
    Was it a good idea.....?...
    Today, 09:45 AM
  • Rolf
    Reply to My covid angel
    by Rolf
    Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
    Today, 09:02 AM
  • Rolf
    Reply to Tough Decisions
    by Rolf
    The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
    Today, 08:49 AM
  • NC Scroller
    Reply to My covid angel
    by NC Scroller
    I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
    Today, 07:27 AM
View All
Working...
X