If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hello all,im a beginner scrollsawer.i have been trying to look for any celestial patterns which include suns,moons and stars if someone can point me in the right direction it would be greatly appreciated
Hey SeaBee--
Hope you found something you could use. The patterns on those sites change quite often and the "Hot Off The Press" category usually contains the new stuff. However, "Temporary Posts" sometimes contains good things as well. Welcome to the forum by the way.
Moon
Hey Sea Bee....are you, or were you, a Sea Bee as in NMCB?? If so, what MOB are you or were you with. I was attached to CBMU 302 for 13 months in Vietnam. If I ever have to go to war again I want to go with the "Bees"!!
If it don't fit, don't force it....get a bigger hammer!!
Rolf, I cover it with clear contact paper (comes off clean without leaving a residue) and draw a grid for the direction I want to cut (ie horizontal or diagonal) to keep the rows even. The rest is all freehand....
I use acrobat reader. The poster feature will enlarge and if it goes to multiple pages it will put in cut marks. Even if the page is over letter size it will spread to multiple pages at 100%.
If it is in PDF form you can open with Inkscape or GIMP and select what you...
Please keep us up to date with any information you receive. I would really like to get into this, but my computer skills are almost nonexistent, I need something that a 74 year old air head 🙄 can figure out. Thanks for sharing.
Do any of you have experience with or know reputability of the YoraHome Laser with CNC Router Engraver? I was checking out Ortur, and Yora kept popping up. Looks like a versatile combo to suppliment scrolling. Just looking for thoughts. https://yorahome.com/collections/cnc...oducts/yora-cn...
Comment