Announcement

Collapse
No announcement yet.

Polls

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Polls

    How do you create a poll on this forum?

    Gill
    There is no opinion, however absurd, which men will not readily embrace as soon as they can be brought to the conviction that it is readily adopted.
    (Schopenhauer, Die Kunst Recht zu Behalten)

  • #2
    Gill,
    After you make the post, go back into the thread and click on "Thread Tools"

    Then there should be the option to "Add poll to thread"

    From there, just follow the directions.

    Bob
    Attached Files
    www.GrobetUSA.com

    Comment


    • #3
      Many thanks, Bob. I'll give it a whirl right now .

      Gill
      There is no opinion, however absurd, which men will not readily embrace as soon as they can be brought to the conviction that it is readily adopted.
      (Schopenhauer, Die Kunst Recht zu Behalten)

      Comment


      • #4
        Originally posted by Gill
        How do you create a poll on this forum?

        Gill
        I think a Lathe would work better than a scrollsaw.

        Comment


        • #5
          Originally posted by Grizz
          I think a Lathe would work better than a scrollsaw.
          There is no opinion, however absurd, which men will not readily embrace as soon as they can be brought to the conviction that it is readily adopted.
          (Schopenhauer, Die Kunst Recht zu Behalten)

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • hotshot
            Reply to Darkening oak
            by hotshot
            I've had very good luck using the oven. The wood does soften, but with oak, that usually isn't a problem. It also darkens all the way through.

            He is a flash from the past where I show some puzzle boxes made with oven darkened oak.

            https://forum.scrollsawer.com/forum/...2-...
            Today, 12:32 AM
          • Misouri Wayne
            Reply to Spiral Blades - Tips & Tricks?
            by Misouri Wayne
            Thanks for the post. I have tried spirals in the past and had lots of issues. I need to set down one day and keep cutting with them until I get the hang of it. Part of my problem may have been covered by your number 7. Tried pine thinking it would be easy to cut but now realize the grain may have...
            Yesterday, 07:05 PM
          • Sandy Oaks
            Reply to Eagle
            by Sandy Oaks
            I agree, a beautiful piece and wonderful cutting. Years ago, my father had Alzheimer. The last six months we had him in the VA center in St. Cloud MN. His wood work shop is still in MN. I could not take it down to TN....
            Yesterday, 12:00 PM
          • Rolf
            Reply to Spiral Blades - Tips & Tricks?
            by Rolf
            I have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
            They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...
            Yesterday, 09:16 AM
          • Jimern
            Reply to Spiral Blades - Tips & Tricks?
            by Jimern
            The best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
            Yesterday, 05:27 AM
          Working...
          X