Announcement

Collapse
No announcement yet.

Spiral Scrollsaw blades

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Spiral Scrollsaw blades

    Are spiral scrollsaw blades available with pin end?

  • #2
    I have never heard of them but there are a lot of things I have never heard of but you can go to this site and email Mike from there, he will be able to tell you. He sells blades, which most of us think are the best.
    Bob

    http://mikesworkshop.com/
    Delta P-20 & Q-3

    I wondered why the baseball was getting bigger. Then it hit me!

    Comment


    • #3
      Thank you. I appreciate the response. I just e-mailed him with some questions.

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • Rolf
        New Toy!
        by Rolf
        A family friends father passed away and he was an avid bird carver. So my nephew is helping the family sell some of his tools. I bought this air cleaner and will b uy most of his carving knives and burrs. And no that is not my workshop! Not even close. ...
        Today, 04:47 PM
      • Rolf
        Reply to EX dust collection holes screwed up a project.!
        by Rolf
        I just did a quick job on my table. Charles Hand has noticed that the adhesive on the new rolls of Contact brand shelf paper leaves a residue. He has changed to The duck brand. I just bought a roll and covered my table with it. It is a tough slick surface. It will be interesting to see how it holds...
        Today, 04:44 PM
      • axor
        Reply to Shawl pins
        by axor

        Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...
        Today, 03:21 PM
      • handibunny
        Reply to EX dust collection holes screwed up a project.!
        by handibunny
        Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
        Today, 09:21 AM
      • Bill Wilson
        Reply to EX dust collection holes screwed up a project.!
        by Bill Wilson
        I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
        Today, 09:06 AM
      Working...
      X